Mini Lathe
My lathe is a Homier Speedway series 7 x 12. I have purchased and made many accesories. This picture
was taken when I first got it back in the summer of 2003. I have made a few modifications to it so far,
and plan to do a few more in the near future and I will add them to this page.
Boring out the center hole of the gear
for the rotary table by mounting it to
the face plate. 2-1-05. Turning the
worm gear shaft.
Using my homemade radius cutter to
turning a knob for the hand wheel for the
Sears 109 lathe.